Get Adobe Flash player

Vulcanised splices of rubber belts

Finger (V-cut) splices

A standard of one- and two-plied belts splices. It meets the highest demands as for the uniformity of thickness and elasticity of belts installed on knife rolls. The final belt is able to travel in both directions. The splice can use various angles. If the belt is intended to work in high temperature or heavy tension conditions, the hidden sewn connections can be installed as well. 

zeby

Angled finger (V-cut) splices

The splice has the properties comparable to original finger connection, but it can be applied in case of smaller pulleys diameter, harder working conditions. the splice is applicable for the belts of two and three plies.
zeby2

Overlapping splices

Overlapping splice is applied to two- and three-plied belts and characterised by high durability. However, once the splice is made, it is strongly recommended to stick to one direction of the belt travel.
zakladka

Rubber belts

Vulcanising of rubber belts is made using the overlapping splice method. the number of inside steps and their dimensions depend on the belt type. The same preparations are undertaken before cold belt gluing.

W naszym Serwisie używamy plików cookies. Korzystając dalej z Serwisu, wyrażasz zgodę na stosowanie plików cookies zgodnie z Polityką prywatności. Wyrażenie zgody jest dobrowolne, w każdej chwili można ją cofnąć poprzez zmianę ustawień dotyczących plików „cookies” w używanej przeglądarce internetowej. Kliknij „Akceptuję”, aby ta informacja nie wyświetlała się więcej.